2. Woodworking

Steam Bending

Read More
48" x 4" Black ABS pipe, mounted to an oak scrap for strength and mounting in a workmate. 1/4" dowels at 6" centers. Lower End cap has an inlet for the steam hose.<br /> <br /> From the Highland Hardware Plans<br /> <a href="http://www.highlandwoodworking.com/buildingasteambox.aspx">http://www.highlandwoodworking.com/buildingasteambox.aspx</a>
1 / 4

48" x 4" Black ABS pipe, mounted to an oak scrap for strength and mounting in a workmate. 1/4" dowels at 6" centers. Lower End cap has an inlet for the steam hose.

From the Highland Hardware Plans
http://www.highlandwoodworking.com/buildingasteambox.aspx

IMG20110423185955

  • 48" x 4" Black ABS pipe, mounted to an oak scrap for strength and mounting in a workmate. 1/4" dowels at 6" centers. Lower End cap has an inlet for the steam hose.<br /> <br /> From the Highland Hardware Plans<br /> <a href="http://www.highlandwoodworking.com/buildingasteambox.aspx">http://www.highlandwoodworking.com/buildingasteambox.aspx</a>
  • About ready to start. a 36"L x 2.75"W x ~1/8" thick strip of cherry on top is the first victim
  • In Process about 5 minutes. Temp probe reading 212°F, condensate dripping out the left, but not cleanly. Took over 30 mins to get steam going, then another few to get the tube up to 212. Need to pre heat the water next time.
  • Pushed too hard, broke at the pivot point. Not an ideal piece, big knot about 9" from top end.<br /> Steamed 15 mins, then another 5 after it didn't bend enough.
  • No Comments
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2023 SmugMug, Inc.